Some minor changes I had to make upon request at Stefanie’s board. The bottom is made out of zebrano veneer. The board has to be sort of pink and must be stiffer in the middle.
From my side, I tried to cut some building time, I hate to glue the two sheets, bottom and [...]
Einträge getagged als 'HowTo Balsa'
Kern#6
02. July 2009von admin· Keine Kommentare · HowTo, HowTo Balsa
Tags:
Core#5
25. January 2009von admin· 1 Kommentar · HowTo Balsa
Found a new trick that is reducing the building time massively.
No matter what technique you use, in any case the core has to be drilled to avoid large bubbles. It can happen that the vakuum will be sucked on the core so hard that the vacuum dies in some areas. Those bubbles are ugly and [...]
Tags:
Core#4
27. December 2008von admin· Keine Kommentare · HowTo Balsa
Here you can see on the picture set how the milling with a template works.
Drill all holes with a 6mm drill. All means, fins and footstraps.
Put 6mm screws through the holes to prevent the template from moving on the balsa.
Trim the balsa with a sharp knife 5-8mm wider then the template. Keep in mind you [...]
Tags:
Software from Denmark
27. December 2008von admin· 1 Kommentar · Computer, HowTo Balsa
I think times, where one with spruce and pencil outlines rocker curves is past. Most of the programs to do that on a computer can be found on the Internet. Software which I mention in this blog is always open SOURCE and thus free of charge. It has been tested on Linux using WINE and [...]
Tags:
